Makerbot Thing-O-Matic

From VoidWarranties - Hackerspace Antwerp, Belgium
(Difference between revisions)
Jump to: navigation, search
(Progress Log)
(Progress Log)
Line 69: Line 69:
 
** Replace the Kapton tape, it could be worn out
 
** Replace the Kapton tape, it could be worn out
  
== 23/06/2013 (berz_) ==
+
===Sun 23th june 2013 (berz_)===
 
* Tried to print something, but after a while I started to lose steps on the X axis. This was also the case when manually controlling the printer to replicator G.
 
* Tried to print something, but after a while I started to lose steps on the X axis. This was also the case when manually controlling the printer to replicator G.
 
* I found out the gear attached to the X axis motor shaft had become loose.
 
* I found out the gear attached to the X axis motor shaft had become loose.
 
* to tighten it I had to take out the Y axis and open up the X assembly partially to reach the X motor shaft with a small allen key.
 
* to tighten it I had to take out the Y axis and open up the X assembly partially to reach the X motor shaft with a small allen key.
 
* After the gear was firmly reattached to the shaft the printer printed smoothly.
 
* After the gear was firmly reattached to the shaft the printer printed smoothly.
 +
 +
===Sat 29th june 2013 (Yashiko)===
 +
* Oddly had pulled of the kapton tape and aluminium foil of the heated bed a couple of days ago.
 +
** It wasn't noted why or what advadages it has.
 +
** I replaced the kapton tape but not the foil. I wanna see if there is a difference in heat distribution on the bed.
 +
** This time I folded the tape over the edges to see if it stays in place longer and better.
 +
 +
* I replaced the broken fan that cools down the printerhead. (I broke one blade myself, so only just that I replaced it)
 +
 +
I did some testing with a new filament: laybrick.
 +
* We got a package to test it out at the local 3D Hubs meeting yesterday.
 +
*TEST 1:
  
 
=Cool Projects we made with Vettige Swa=
 
=Cool Projects we made with Vettige Swa=

Revision as of 16:57, 30 June 2013


Makerbot Thing-O-Matic
What:
3D printer
IMG 2876.jpg
Participants:
Yashiko, Oddly
Category:
Infrastructure
Locations:
Den Bunker
IMG 2844.jpg

Thing-O-Matic instructions

Contents

Who is "Vettige Swa"

Building the printer

building instructions

How does this thing work

Turning it on

Calibration

This must be done every time you turn on the printer

Printing a testmodel

Progress Log

Mon 3th June 2013

Tue 4th June 2013

As we came out of hyperspace with spaceship Thing-O-Matic we immediately began with the upgrade of the Arduino Mega 2560 inside.

Our findings:

Sun 23th june 2013 (berz_)

Sat 29th june 2013 (Yashiko)

I did some testing with a new filament: laybrick.

Cool Projects we made with Vettige Swa

Personal tools
Namespaces
Variants
Actions
Navigation
Toolbox
Content Creation
Belgian Spaces